H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 207)

197
Field Description
State Select state of a member port: Selected or Unselected.
Reason for being Unselected
Reason why the state of a member port is Unselected. For a selected member
port, this field is displayed as a hyphen (-).
Setting LACP priority
1. Select Network > LACP from the navigation tree.
2. Click Setup.
Figure 180 The Setup tab
3. In the Set LACP enabled port(s) parameters area, set the port priority, and select the ports in the
chassis front panel.
4. Click Apply in the area.
Table 69 Configuration items
Item Description
Port Priority Set a port LACP priority.
Select port(s) to
apply Port Priority
Select the ports where the port LACP priority you set will apply on the chassis front panel.
You can set LACP priority not only on LACP-enabled ports but also on LACP-disabled ports.
5. In the Set global LACP parameters area, set the system priority.
6. Click Apply in the area.