H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 71)

61
Item Description
Port Type
Set the type of
the port to be
configured.
Configure ports for a local mirroring group:
• Monitor Port—Configures the monitor ports for the local mirroring
group.
• Mirror Port—Configures mirroring ports for the local mirroring group.
Stream
Orientation
When you select Remote Source from the Type of the mirroring group list, set the direction of
the traffic monitored by the monitor port of the mirroring group:
• both—Mirrors both received and sent packets on mirroring ports.
• inbound—Mirrors only packets received by mirroring port.
• outbound—Mirrors only packets sent by mirroring ports.
Select port(s)
Click the ports to be configured on the chassis front panel. If aggregate interfaces are
configured on the device, the page displays a list of aggregate interfaces below the chassis
front panel. You can select aggregate interfaces from this list and configure them as
mirroring ports of a port mirroring group.
Local port mirroring configuration example
Network requirements
As shown in Figure 54 , Configure local port mirroring on Switch A to monitor the packets received and
sent by the Marketing department and Technical department.
Figure 54 Network diagram
Configuring local port mirroring
1. Add a local mirroring group:
a. From the navigation tree, select Device > Port Mirroring.
b. Click the Add tab.
The page for add mirroring groups appears.
c. Enter 1 for Mirroring Group ID.
d. From the Type list, select Local.
e. Click Apply.