H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 219)

209
Recommended LLDP configuration procedure
Step Remarks
1. Enabling LLDP on ports .
Optional.
By default, LLDP is enabled on ports.
Make sure LLDP is also enabled globally, because LLDP can work on a port
only when it is enabled both globally and on the port.
2. Configuring LLDP
settings on ports .
Optional.
LLDP settings include LLDP operating mode, packet encapsulation, CDP
compatibility, device information polling, trapping, and advertisable TLVs.
By default:
• The LLDP operating mode is TxRx.
• The encapsulation format is Ethernet II.
• CDP compatibility is disabled.
• Device information polling and trapping are disabled.
• All TLVs except the Location Identification TLV are advertised.
3. Configuring global LLDP
setup .
Required.
By default, global LLDP is disabled.
To enable LLDP to work on a port, enable LLDP both globally and on the port.
4. Displaying LLDP
information for a port .
Optional.
You can display the local LLDP information, neighbor information, statistics,
and status information of a port, where:
• The local LLDP information refers to the TLVs to be advertised by the local
device to neighbors.
• The neighbor information refers to the TLVs received from neighbors.
5. Displaying global LLDP
information .
Optional.
You can display the local global LLDP information and statistics.
6. Displaying LLDP
information received
from LLDP neighbors
.
Optional.
You can display the LLDP information received from LLDP neighbors.
Enabling LLDP on ports
1. Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed. This tab displays the enabling status and operating
mode of LLDP on a port.
2. Select one or more ports and click Enable beneath the port list to enable LLDP on them.
To disable LLDP on a port, select the port and click Disable.