H3C Technologies H3C WX5500E Series Access Controllers User Manual
Page 238
228
b.
Click the GigabitEthernet1/0/1 port name in the port list.
c.
Click the Status Information tab at the lower half of the page.
The output shows that port GigabitEthernet 1/0/1 is connected to an MED neighbor device.
Figure 203 The status information tab (1)
2.
Display the status information of port GigabitEthernet1/0/2 on Switch A:
a.
Click the GigabitEthernet1/0/2 port name in the port list.
b.
Click the Status Information tab at the lower half of the page.
The output shows that port GigabitEthernet 1/0/2 is connected to a non-MED neighbor device
(Switch B), as shown in
.
Figure 204 The status information tab (2)
3.
Tear down the link between Switch A and Switch B.
4.
Click Refresh to display the status information of port GigabitEthernet1/0/2 on Switch A.
The updated status information of port GigabitEthernet 1/0/2 shows that no neighbor device is
connected to the port, as shown in
.