H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 221)

211
Setting LLDP parameters for a single port
1. Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed.
2. Click the icon for the port you are configuring.
On the page as shown in
Figure 189 , the LLDP settings of the port are displayed.
Figure 189 Modifying LLDP settings on a port
3. Modify the LLDP parameters for the port as described in Table 78 .
4. Click Apply.
A progress dialog box appears.
5. Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Table 78 Configuration items
Item Description
Interface Name Displays the name of the port or ports you are configuring.
DLDP State
Displays the LLDP enabling status on the port you are configuring.
This field is not available when you batch-configure ports.