Grass Valley LVS 100 v.3.15 - Manual (Page 285)

Lever Adjustment
Profile LVS Event Management System Instruction Manual
8-5
To adjust the N position, proceed as follows:
7. Slowly move the lever backward until the lock is disengaged.
If you move the lever back too quickly, move the lever forward again until
the lock is re–engaged and then repeat this step.
8. Press CONT.
Pressing CONT causes the instrument to adjust the N (Lock) position. The
following message appears:
[STEP 4]
1. Move leverto position STILL.
2. Push CONT key.
To adjust the STILL position, proceed as follows:
9. Move the lever backward until the lock is engaged.
10. Press CONT.
Pressing CONT causes the instrument to adjust the STILL (Lock) position.
The following message appears:
[STEP 5]
1. Turn on the lever switch.
2. Move leverto position REV SPRING.
3. Push CONT key.
N (Lock) Position
STILL (Lock) Position