Grass Valley LVS 100 v.3.15 - Manual (Page 311)

Removal and Installation Procedures
Profile LVS Event Management System Instruction Manual
9-21
1. Open the operation panel. Refer to Procedures for Operation Panel on
page 9–13.
2. Use the long-nose pliers to disconnect the two cables going to the power
switch, and the ground cable connected to the bottom of the chassis.
3. Use the 2.0 mm hex wrench to remove the two screws securing the RFI filter
to the rear of the Live Controller.
4. Remove the RFI filter completely.
RFI Filter
Power Switch
RSĆ422 Cable (W005) with Connector
going to J140 on the CPU board.
RSĆ422 Cable (W006) with Connector
going to J141 on the CPU board.
To Power Switch
To Chassis Ground
From RFI Filter
To CP2 on the
Power Supply
Chassis Ground
Nut M3 7MM,
HEX
Figure 9-11: Power Switch, RFI Filter and RSĆ422 Connectors Removal (Inside View)
RFI Filter