Grass Valley LVS 100 v.3.15 - Manual (Page 317)

Diagnostics
Profile LVS Event Management System Instruction Manual
9-27
Starting the Diagnostic Routine
Turn the Power on while holding EVENT and TIME buttons. The following
menu appears on both upper and lower LCDs of the Live Controller.
**** DIAG ****
CONT: Starting tests or configure.
0: Starting up the system.
The letter(s) to the left of the colon (:) indicates keys on the instrument that you
should press to select a test procedure. These keys also light to indicate that they
are available for test procedures.
The messages following the colon (:) indicate the functions you can select.
NOTE. When the key configuration is set to the Alternate key, the EVENT key
instead of the 0 key will light when you enter the diagnostics routine. For more
detail about the Alternate key configuration, refer to About Key Configuration
on page 7–5.
Press 0 to exit from the diagnostic routine and start the Live Controller. When
you want to continue the test procedure, press CONT. The following Diagnostic
Main menu appears.
[MAIN MENU] 0: Exit menu.
1: MEMORY 2: RS422 3: KEY/LED 4: LCD
5: SLNID/ADC/ENCDR/CLTCH 6: S-E2PROM
SEARCH: KEY PLACE SELECT
Confirm that all keys corresponding to test procedures you can select are lit.
Press a key to execute the corresponding test.