Grass Valley NV9648 v.1.1 - Manual (Page 60)

50
Operation
Behavioral Models
Saved NV9648 Assignments
Every time an operator, at the NV9649 server, assigns a destination to an NV9648 client or
assigns a source to a source button of a client, those assignments are recorded within the
NV9000 system controller. Therefore, if and when the system controller undergoes a power
cycle, the source and destination assigments of all the NV9648 clients are preserved.
The NV9649 (server) can be configured so that up to 12 different sets of client assignments (or
“set-ups” as they are called in the NV9649’s menu) can be defined, selected, redefined, and
otherwise managed as different operators choose.
A NV9649 always has a default setup and may have eleven other named setups.
Button Functions
There are 5 button function types for a panel in client mode:
Destination Lock Destination Protect Quick Source
Source Take
These are described in Buttons for the Client Model on page 57.
Each control unit can switch up to 9 sources — on ‘Quick Source’ buttons — to its destination.
Each unit can switch at least 6 sources. At the NV9649, you can change any or all of the sources
of the control unit and you can change its destination.
See Operating Methods on page 66 for how to change sources and destinations.
Please refer to the NV9649 Users Guide for information regarding the use of the NV9649.
Standalone Model
When the panel is in “standalone” mode, it functions much the way it does in “client” mode, but
it does not require the presence of an NV9649. It has a few added button function types, in
particular a destination selection button.
Under the standalone model, each NV9648 has 3 identical sections:
Each section functions as a complete and separate control unit. Each control unit corresponds to
a single destination and its display shows that destination. If the unit has no destination
selected, the display reads “NO DEST.” The function buttons allow simple all-level takes to, and
locks on, that destination. The unit can also execute system salvos.
1
Each control unit is completely unrelated to, and unaffected by, the other control units.
Function buttons (9)
Display (8 characters)
1. Please refer to the NV9000-SE Utilities Users Guide for information regarding the construction of salvos.