Grass Valley NV9648 v.1.1 - Manual (Page 82)

72
Operation
Setup Mode
the illustration above, the part number is SV1171-00 and the revision is A0. The CPLD version
number is 00:
Panel Test
Press the ‘Panel Test Mode’ button to perform a panel test. The test reveals the color and
viability of the 3 displays and the function buttons.
The submenu shows a ‘Push to Test’ button at the lower right:
Press that button to proceed to the display test.
The display test should show that the pixels of the character elements of the displays are
brightly lit.
Press the ‘Push to Test’ button again to start the color test. The first segment of this test shows all
the buttons illuminated in high-tally green. Press the ‘Push to Test’ button again. The next
segment shows low-tally green.
Keep pressing that button until all the colors have been displayed — green, amber, yellow, red,
blue, purple, grey, and white and high and low-tally for each. At this point, the displays now read
button test. Pause for a moment. Do not press ‘Exit’:
Press any button to test it. The button will flash a few times rapidly and the number of the
button will appear on the display.
Pressing the exit button will terminate the button test and return you to the initial display of
setup mode. At this point
— if you have a assigned your NV9648 a suitable panel ID — you may
connect your NV9648 to the panel network of your NV9000 system.
APP APP
SV1171- SV1171-
00 A0 00 A0
FIRMWARE FIRMWARE
VERSION VERSION
00 00
EXIT EXIT
PUSH PUSH
TO TO
TEST TEST
BUTTON T E S T
EXIT EXIT