Yaskawa MP3200iec - Manual (Page 28)

9 Installation
26 YASKAWA America, Inc. MP3200iec Hardware Manual YAI-SIA-IEC-5
6. Press the connector back into the CPU Unit.
7. Hold the connector, and while pressing it toward the CPU Unit’s internal circuit board (the board on the side of the
clamp), move the Battery and the battery holder into the CPU Unit.
Note: If this procedure is not followed, the battery leads may be pinched between the Battery and the circuit board, causing stress on the
leads. If that occurs, the battery holder will bulge after step 8 of the procedure.
8. Close the battery holder and confirm that the BAT indicator on the CPU Unit is not lit.
This completes Battery replacement.
Press in.
Move the Battery.
CPU Unit internal circuit board
(on the side of the clamp)
2 battery leads
Hold the connector
and press in.
Clamp