Yaskawa MP3200iec - Manual (Page 31)

11 LED Indicators
YASKAWA America, Inc. MP3200iec Hardware Manual YAI-SIA-IEC-5 29
11 LED Indicators
The following table shows the indicators that show the operating status of the controller and error information.
‹
Seven Segment Display
The following situations use the seven segment display:
• Manufacturing: During programming the seven segment display outputs "FLASH...". When finished, the seven
segment display outputs "donE".
• Startup: If the controller cannot boot because of a bad firmware image check sum, the seven segment display outputs
"bOOt ERROR".
• IP Address: If the TEST switch is ON, then the seven segment display outputs the IP address.
• Firmware update: During programming the seven segment display outputs "FLASH...". When finished, the seven
segment display outputs "donE".
Indicator Color Status
RDY Green Lit during normal operation.
RUN Green Lit during execution of user program.
ALM Red Lit/blinking when warning occurs.
ERR Red
ON at initial power-up while firmware is loading. Turns off if
firmware is valid. Lit/blinking when malfunction occurs.
BAT Red Lit during battery alarm.
M-ALM Red Lit when a MECHATROLINK Communications Error occurs.
RDY
RUN
ALM
BAT
M-ALM
ERR