Yaskawa VCD 723 - Manual (Page 21)

2 Installation and Start-up
15 Pre-installation Considerations
9/15/93
Location of the VCD 723 is important to achieve proper performance and
normal operating life. The unit should be installed in an area where it will be
protected from the following:
●
Direct sunlight, rain or extreme (condensing) moisture.
●
Corrosive gases or liquids.
●
Vibration, airborne dust or metallic particles.
All equipment is tested against defect at the factory. Any damages or shortages
evident when the equipment is received must be reported immediately to the
commercial carrier who transported the equipment. Assistance, if required, is
available from your MagneTek representative. Always refer to the order number,
equipment description, and serial number when contacting MagneTek.
Remove the protective shipping material from around the equipment. Remove
all packing material. Inspect for loose wiring. Make sure all contact wedges and
other shipping devices have been removed.
For long periods of storage, equipment should be covered to prevent corrosion,
and should be placed in a clean, dry, location. If possible, equipment should be
stored in its original crating. Periodic inspection should be made to ensure that
the equipment is dry and that no condensation has accumulated. The equipment
warranty does not cover damage due to improper storage. Assistance, if
required, is available from your MagneTek representative.
For effective cooling as well as proper maintenance, the VCD 723 must be
installed vertically. Use the holes provided on the back of the drive for
installation. There MUST be a MINIMUM 6 inch clearance above and below
the VCD 723 enclosure. A MINIMUM 3 inch clearance is required on the left
side of the VCD 723 enclosure. See Figure 2 for physical dimensions.
Pre-installation
Considerations
Receipt of
Shipment
Unpacking
Repacking
Physical
Installation