Yaskawa MP2000 Series - Manual (Page 13)

Page 13
MP2000.02, 1/18/2011
Data subject to change without notice
Yaskawa America, Inc.
1.6 Switch Settings
1.6.1 SW 1 Settings
Name Status Operation Mode Function Default
BRS0
BSR0:ON BSR1:ON 4M
BSR0:ON BSR1:OFF 2M
BSR0:OFF BSR1:ON 1M
BSR0:OFF BSR1:OFF 0.5M
PCLINK Baud Rate Setting
ON
BRS1 ON
SBRS
ON 19200 bps
Serial Port Baud Rate Setting OFF
OFF 9600 bps
HOLD
ON Holding Mode
Link Data Status at Fault Settings OFF
OFF CLEAR Mode
INIT
ON
Hardware Switch
Enabled Baud Rate, Station Number Setting
Selection
OFF
OFF
Software Settings
Enabled
TEST
ON TEST Mode
Run Mode Selection OFF
OFF Normal Operation Mode
1.6.2 Rotary Switch
Name Status Operation Mode Default Notes
ADRS X10 0-3 Station Address (10 Digits) 0 Station Address 1~32
Other settings not possible
ADRS X1 0-9 Station Address (1 Digit) 1
The status of each station is enabled only in a power ON state. (Changes after power ON will not be detected.)