Yaskawa MP2000 Series - Manual (Page 20)

Page 20
TM.MP2000.02, 1/18/2011
Data subject to change without notice
Yaskawa America, Inc.
Á
3.2 "Parameter Setting" Tag Screen
Set the various parameters necessary for the PCLINK transmission system in the "Transmission Parameters" tag
screen.
Configuration Information
This displays the PCLINK-01 configuration information. The configuration information is the same as the information
displayed in the details area of the module configuration definition window.
Circuit Number: Sets the PCLINK-01 circuit number.
I/O Start Register: Sets the lead number of the I/O registers (OWxxxx, IWxxxx) used by the PCLINK-01.
I/O End Register: Sets the end number of the I/O registers (OWxxxx, IWxxxx) used by the PCLINK-01.
Motion Start Register: Cannot be set in PCLINK-01.
Motion End Register: Cannot be set in PCLINK-01.
It is possible to change the configuration information in the Details area of the Module Configuration Definition
window. At this time, the circuit numbers will not be duplicated in the other PCLINK-01.
Station No
Set the PCLINK-01 local station number in a range of 1~32.
Group No
Set the group address used in cases where data transmission is performed for each group during message
transmission in a range of 129~160.