Epson FX-980 - Manual (Page 128)

5-2 Changing Printer Settings From the Printer’s Control Panel
R4C3430
Rev. C
A5 size CHAP5.FM
5/4/99 Pass 0
L Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
Selecting a Built-In Font
Your printer comes with the three built-in fonts shown in the table
below. You can also choose from the following six pitch (character
size) settings: 10, 12, 15, 17, or 20 cpi (character per inch), or
proportional spacing.You can select the font and pitch using the
buttons on the printer’s control panel as described below.
Note:
Settings you make in your application programs usually override
settings you make from the printer’s control panel. For best results, use
your application to select a font and pitch.
Follow these steps to select a built-in font or pitch using the
buttons on the control panel:
1. Make sure that the printer is not printing. If it is, press the
Pause button to stop printing.
2. To select a font, press the Font button until the two Font lights
indicate the font you want as shown below.
Font Sample
Draft
Roman
Sans Serif
Font lights Font
o n Draft
n o Roman
n n Sans Serif
n = On, o = Off