RISCO Group axesplus® MAP Editor - Manual (Page 36)

User Manual for MAP Editor
Uncontrolled when printed © RISCO Group 28
15. To add a relay, select Relay from the access control devices and drag it to the map at a desired
location.
Figure 25: Relay Added to the Map
You may configure relay properties. The following table describes the relay properties.
Table 6: Relay Properties
Field Description
(Name) This name is generated when you select the name of the
relay from the available list from the Name field below.
Active State Select the relay state (active/inactive) which should be
reflected in ACUS as default.
Back Colour You can select the background colour for the relay. You
can select from the available options.
Background Image This image will appear as a background for the relay.
You can attach a JPEG or BMP image for the relay.
Background Image Layout You can change the layout of the image attached for the
relay. You can tile, stretch or zoom in the image. You
may also keep the image in the centre of the map.
Blink Select True to activate blinking action for the relay.
Blink Colour Select the Blink Colour which will appear when the
relay is blinking.
Blink Element Not Applicable