TA Triumph-Adler DC 2435 - Manual (Page 48)

FAX Operation (Basic)
3-8
Selecting the Density
Adjust the density when scanning originals.
1 Press [Color/Image Quality], and then [Density].
You can see a preview of the image to be sent by
pressing [Preview]. For details, refer to Previewing
Images on page 3-24.
2 Select the density.
The density can be selected in 13 levels from -3
(lighter) to +3 (darker). In Quick Setup, the density
is in seven levels. To adjust the density in 13 levels,
press [More].
3 Press [OK].
Select of Original Image
Select the original image.
1 Press [Image Quality], and then [Original
Image].You can see a preview of the image to be
sent by pressing [Preview]. For details, refer to
Previewing Images on page 3-24.
Key Description
Sub Address To communicate using the sub address, press
this key. For details, refer to Sub Address
Communication on page 4-45.
Transmission Start
Speed To change the transmission start speed, press
this key. Select the speed from 33,600 bps,
14,400 bps, and 9,600 bps.
ECM ECM (error correction mode) prevents distortion
of the fax image by automatically resending any
parts of the data that were not correctly sent due
to the effects of noise on the telephone line during
transmission. To change the ECM communication
setting, press this key.
Encrypted
Transmission To send faxes using encryption, press this key.
For details, refer to Encryption on page 6-29.
Darker
Density
Normal Lighter
Cancel OK Add Shortcut
Status 10/10/2010
Destination
0 +1 +2 +3 -1 -2 -3
-2.5 -1.5 -0.5 +0.5 +1.5 +2.5
100%
A4
A4
Preview
Original
Zoom
Send :
:
: