PLANET GS-4210-24P2S - Manual (Page 310)

User’s Manual of GS-4210-24P2S
The CLI provides the following modes:
User Mode
When the operator logs into the CLI, the User Mode is the initial mode. The User Mode contains a limited set of commands. The
command prompt shown at this level is:
Command Prompt: GS-4210-24P2S >
Privileged Mode
To have access to the full suite of commands, the operator must enter the Privileged Mode. The Privileged Mode requires
password authentication. From Privileged Mode, the operator can issue any Exec command to enter the Global Configuration
mode. The command prompt shown at this level is:
Command Prompt: GS-4210-24P2S #
Global Config Mode
This mode permits the operator to make modifications to the running configuration. General setup commands are grouped in
this mode. From the Global Configuration mode, the operator can enter the Interface Configuration mode. The command
prompt at this level is:
Command Prompt: GS-4210-24P2S (Config)#
From the Global Config mode, the operator may enter the following configuration modes:
6.1 User Mode Commands
6.1.1 enable command
Description:
Turn on privileged mode command
Syntax:
enable
Example:
GS-4210-24P2S> enable
Password:
GS-4210-24P2S#
310