PLANET LRP-822CS - Manual (Page 23)

User’s Manual of LRP-822CS
23
- For 1000BASE-SX/LX SFP transceiver module: From 550 meters (multi-mode fiber) to 10/30/50/70/120 kilometers
(single-mode fiber).
- For 100BASE-FX SFP transceiver module: From 2 kilometers (multi-mode fiber) to 20/40/60 kilometers (single-mode
fiber).
■ Console Port
The console port is a RJ45 port connector. It is an interface for connecting a terminal directly. Through the console port, it
provides rich diagnostic information including IP Address setting, factory reset, port management, link status and system
setting. Users can use the attached DB9 to RJ45 console cable in the package and connect to the console port on the
device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
■ Reset Button
On the left of the front panel, the reset button is designed to reboot the LRP Managed Switch without turning off and on the
power. The following is the summary table of the Reset button functions :
Reset Button Pressed and Released Function
< 5 sec: System Reboot Reboot the LRP Managed Switch.
> 5 sec: Factory Default
Reset the LRP Managed Switch to the Factory Default
configuration. The LRP Managed Switch will then reboot and
load the default settings shown below:
。 Default Username: admin
。 Default Password: admin
。 Default IP Address: 192.168.0.100
。 Subnet Mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; it helps monitor and troubleshoot
when needed. Figure 2-1-2 shows the LED indications of these LRP Managed Switches.
LED Indication
Figure 2-1-2 LRP-822CS LED Panel