2 access control list configuration – PLANET XGSW-28040 User Manual

Page 208

Advertising
background image

User’s Manual of XGSW-28040

based ACE will not get matched by IP and ARP frames.

ARP

: The ACE will match ARP/RARP frames.

IPv4

: The ACE will match all IPv4 frames.

IPv4/ICMP

: The ACE will match IPv4 frames with ICMP protocol.

IPv4/UDP

: The ACE will match IPv4 frames with UDP protocol.

IPv4/TCP

: The ACE will match IPv4 frames with TCP protocol.

IPv4/Other

: The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.

IPv6

: The ACE will match all IPv6 standard frames.

Action

Indicates the forwarding action of the ACE.

Permit

: Frames matching the ACE may be forwarded and learned.

Deny

: Frames matching the ACE are dropped.

Rate Limiter

Indicates the rate limiter number of the ACE. The allowed range is 1 to 16. When

Disabled is displayed, the rate limiter operation is disabled.

Port Redirect

Indicates the port redirect operation of the ACE. Frames matching the ACE are

redirected to the port number. The allowed values are Disabled or a specific port

number. When Disabled is displayed, the port redirect operation is disabled.

CPU

Forward packet that matched the specific ACE to CPU.

CPU Once

Forward first packet that matched the specific ACE to CPU.

Counter

The counter indicates the number of times the ACE was hit by a frame.

Conflict

Indicates the hardware status of the specific ACE. The specific ACE is not

applied to the hardware due to hardware limitations.

Buttons

Auto-refresh

: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.

: Click to refresh the page.

4.10.2 Access Control List Configuration

This page shows the Access Control List (ACL), which is made up of the ACEs defined on this switch. Each row describes the

ACE that is defined. The maximum number of ACEs is 512 on each switch.

Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for internal protocol, cannot be edited or

deleted, the order sequence cannot be changed and the priority is highest.

The Access Control List Configuration screen in

Figure 4-10-2

appears.

208

Advertising