PLANET XGSW-28040 - Manual (Page 538)

User’s Manual of XGSW-28040
release : Release the current owner of the receiver.
The owner can either be "<none>" if the receiver is not currently owned by anyone, it can be
"<Configured through local management>" if it's currently set up by CLI or Web, or it can be anything
else if is set-up through SNMP. You can only (re-)configure the receiver if it is not currently owned by
anyone or owned by CLI or Web. If this argument is specified, the remaining arguments are ignored.
<timeout> : Receiver timeout measured in seconds. The switch decrements the timeout once per second, and as
long as it is non-zero, the receiver receives samples. Once the timeout reaches 0, the receiver and all
its configuration is reset to defaults. Valid range is 0 - 2147483647 seconds.
<ip_addr_host> : IPv4/IPv6 address or a hostname identifying the receiver.
<udp_port> : Receiver's UDP port. Valid range is 0 - 65535.
Use 0 to get default port (which is 6343).
<datagram_size> : Maximum datagram size. Valid range is 200 - 1468 bytes.
Default is 1400 bytes.
sFlow FlowSampler
Description:
Set or show flow sampler configuration per port.
When operational, the sampling rate 'N' is rounded off to the nearest supported value.
Syntax:
sFlow FlowSampler [<port_list>] [<sampling_rate>] [<max_hdr_size>]
Parameters:
<port_list> : Port list or 'all'. Default: All ports.
<sampling_rate> : Specifies the statistical sampling rate
The sample rate is specified as N to sample 1/Nth of the packets in the monitored flows. There are no
restrictions on the value, but the switch will adjust it to the closest possible sampling rate.
0 disables sampling.
<max_hdr_size> : Specifies the maximum number of bytes to transmit per flow sample.
Valid range is 14 - 200 bytes. Default: 128 bytes.
sFlow CounterPoller
Description:
Set or show counter polling interval configuration per port.
Syntax:
538