ProSoft Technology MVI69-DNP - Manual (Page 100)

MVI69-DNP ♦ CompactLogix or MicroLogix Platform Reference
DNP 3.0 Master/Slave Communication Module
Page 100 of 129 ProSoft Technology, Inc.
November 3, 2008
System Configuration Errors
Error
Code Name Description
100 Too many binary input
points Too many binary input points are configured for the module.
Maximum value is 7680
101 Too many binary output
points Too many binary output points are configured for the module.
Maximum value is 7680
102 Too many counter
points Too many counter points are configured for the module.
Maximum value is 240
103 Too many analog input
points Too many analog input points are configured for the module.
Maximum value is 480
104 Too many analog input
points Too many analog output points are configured for the
module. Maximum value is 480
105 Too many binary input
events Too many binary input events are configured for the module.
Maximum value is 400.
106 Too many analog input
events Too many analog input events are configured for the module.
Maximum value is 400.
107 Invalid analog input
deadband Deadband value for analog input events is out of range.
Value must be in the range of 0 to 32767.
108 Not enough memory There is not enough memory in the module to configure the
module as specified.
109 Invalid block transfer
delay for blocks
error/status blocks Block transfer delay value specified is too low.
110 File count invalid The file count must be in the range of 0 to 6.
111 Invalid file record size The file record size must be in the range of 1 to 120.
112 Invalid block
identification code for
file The file block transfer code must be in the range of 100 to
120.
DNP Port Configuration Errors
Error
Code Name Description
212 Invalid DNP address The DNP address specified in the configuration is not valid (0
to 65534).
213 Invalid DNP port baud
rate The baud rate code specified in the configuration is not valid.
219 Invalid DNP data link
layer confirm mode The data link confirmation mode code is not valid in the
configuration.
220 Invalid DNP data link
confirm time-out The data link time-out period specified in the configuration is
0. It must be an integer in the range of 1 to 65535.
222 Invalid DNP
select/operate arm time
duration The select/operate arm timer is set to 0. It must be an integer
in the range of 1 to 65535.
223 Invalid DNP application
layer confirm time-out The application layer confirm time-out value is set to 0. It
must be an integer in the range of 1 to 65535.
224 Invalid DNP write time
interval The write time interval is not in the data range in the
configuration. The value must be in the range of 0 to 1440.