Teradek Ranger Micro 5000 3G-SDI/HDMI Wireless Receiver - Manual (Page 21)

Physical Properties
Power and Connect
1. Connect a power source to the transmitter and receiver using the included A/C adapter. If the
receiver is equipped with battery plate accessories, attach a compatible battery ( Gold or V mount ).
2. Connect the output from your video source to either the SDI or HDMI input ( C or E ) on the
transmitter.
3. Connect either the SDI or HDMI output ( D or J ) from the receiver to the video input on your monitor.
4. Turn the units on by moving the power switches on both the transmitter and receiver (I) to the ON
position.
5. NOTE: If mounting the receiver upright on a stand above the monitor, use a right-angle SDI adapter
to relieve any strain caused by the weight of the cable, and to avoid damaging the SDI output’s
internal connectors.
6. Attach two 2dBi antennas to the transmitter and five antennas to the receiver via the threaded RP-
SMA connectors. IF USING "H" (HORIZONTALLY POLARIZED) ANTENNAS: Attach one “H” antenna
to the connector in the back of the transmitter (closest to the rear connectors), and one 2dBi
antenna to the opposite connector. Attach the three 2dBi antennas to the receiver’s center
connectors and the two “H” antennas to the left and right connectors
7. Move the power switches on both the transmitter and receiver (I) to the ON position. Video appears
within a few seconds.
Teradek User Manual
Page 21 Ranger Micro | Mk II