Teradek Ranger Micro 5000 3G-SDI/HDMI Wireless Receiver - Manual (Page 47)

Video Settings Configuration
Display Settings
Use the Display Settings to control the OLED display operation. By default, the OLED display will invert
every 30 minutes. You can set the display to invert every 30 minutes (lengthens the display life), or it can
dim or turn off after either 10 minutes or 10 seconds.
• Rotate 180°
• Invert every 30 min
• Dim every 10 min
• Dim after 10 sec
• Dim after 10 min
• Off after 10 sec
• No Burnin Prevention
HDMI/SDI Output (Ranger Mk II RX only)
You can choose to match the video source’s resolution ( Same As Input ) or choose from the resolutions
list. If using the receiver with a recorder or monitor that is sensitive to video signal changes, select
Continuous Output to ensure the signal stays constant even if the link is interrupted. Keep in mind that
selecting Continuous Output adds a small delay to the video output. Selecting SD , HD , or 6G-
UHD matches the video source's frame rate while adjusting the resolution. This is useful for when you
need to down-convert a 4K video to display on an HD monitor.
Teradek User Manual
Page 47 Ranger Micro | Mk II