Maxtor ATLAS 10K III - Manual (Page 106)

SCSI Description
5-42 Maxtor Atlas 10K III
 +PKVKCVQT %JCPIGCDNG /QFG 2CIGU
Table 5-53 lists the mode pages that are supported by the drive. An initiator can
change these pages by supplying them, with the desired changes included, in the
MODE SELECT command’s data-out buffer transfer.
The initiator should first use a MODE SENSE command to read the appropriate pages
and leave non-changeable values as read when the initiator subsequently writes the
changeable pages with the MODE SELECT command. If a non-changeable field
contains an invalid value, the drive returns a CHECK CONDITION status.
Table 5-53 Initiator-Changeable Mode Pages
NOTES:
1. This page is not supported by the SCSI-1/CCS Operating Mode.
2. The Notch and Partition page is changeable but NOT savable.
3. XOR is currently disabled and page is not changeable.
2CIG %QFG 2CIG 0COG (WPEVKQP 5K\G +P $[VGU
00h Unit Attention Control Page
Unit Attention report-
ing (enables or dis-
ables)
4
01h
Read-Write Error Recovery Page
Medium Access Error
recovery and report-
ing procedures for
READ and WRITE
commands
12
02h Disconnect-Reconnect Page
Bus behavior during
data transfers
16
07h 1 Verify Error Recovery Page
Medium Access Error
recovery and report-
ing procedures for the
VERIFY command
12
08h
1 Caching Page Cache policy 20
0Ah
1 Control Mode Page
Command processing
policy
12
0Ch Notch and Partition Page
2
Drive geometry re-
porting
24
10h XOR Control Page
Controls XOR operat-
ing parameters
24
19h Port Control Page
Defines port control
parameters
8
1Ah Power Condition Page
Enable and set time
intervals for Idle and
Standby modes
12
1Ch 1
Information Exceptions Control
Page and operations of specific
informational exception condi-
tions.
Defines methods to
control reporting
12
39h Maxtor-Unique Page 22