Maxtor ATLAS 10K III - Manual (Page 136)

SCSI Description
5-72 Maxtor Atlas 10K III
 #U[PEJTQPQWU +PHQTOCVKQP 2TQVGEVKQP #+2
To start AIP:
1. Make sure “AIP Generation Disabled” (byte 10, bit 3) is
cleared
. Default
is 0.
2. Make sure “AIP Checking Enabled” (byte 10, bit 2) is set for EACH. This
bit is maintained uniquely for each unique initiator ID that senses it or
selects it, so all initiators that want to participate in AIP must set this for
themselves. Default is 0.
3. Send a negotiation message (SDTR, WDTR, or PPR) with valid AIP data.
The drive will check to see if it received valid AIP data from the host for
the entire negotiation message. If so, AIP is activated and remains so for
as long as that initiator is still valid. If not, no errors are reported, and
another attempt is made at the next negotiation.