Maxtor ATLAS 10K III - Manual (Page 50)

Installation
3-24 Maxtor Atlas 10K III
 /QWPVKPI 5ETGY %NGCTCPEG
The printed-circuit board assembly (PCBA) is very close to the mounting holes.
Figure 3-9 specifies the clearance between the screws in the mounting holes and the
PCBA. Do not use mounting screws longer than the maximum lengths specified in
Figure 3-9. The specified screw length allows full use of the mounting-hole threads,
while avoiding damaging or placing unwanted stress on the PCBA. Clearance from
the drive to any other surface (except mounting surfaces) must be a minimum of
1.25 mm (0.05 inches).
(KIWTG   Mounting Screw Clearance for Maxtor Atlas 10K III Drive
Head/Disk
Assembly
Printed-
Circuit
Board
Drive
Mounting
Screw
4.78 mm Maximum
Bottom Depth
(0.188 Inches)
Printed-
Circuit
Board
6.35 mm Maximum
Side Depth (0.25 Inches)
A
B
Shock Clip
%#76+10 The PCB is very close to the mounting holes. Do not exceed the speci-
fied length for the mounting screws. The specified screw length allows full
use of the mounting-hole threads, while avoiding damaging or placing
unwanted stress on the PCB.
Figure 3-9 specifies the minimum clearance between the PCB and the
screws in the mounting holes. The maximum torque applied to the
screws must not exceed 8.7 inch-pounds (1.00 N-m).