Maxtor ATLAS 10K III - Manual (Page 73)

SCSI Description
Maxtor Atlas 10K III 5-9
 .KPMGF %QOOCPFU
An I/O Process (task) may contain multiple commands that are linked together. The
initiator communicates this condition of linked (or unlinked) commands by setting (or
clearing) the Link bit of the Command Descriptor Block’s control word. A linked
command is one in which the Link bit in the Command Descriptor Block is set.
After successful completion of a linked command the drive sends an
INTERMEDIATE status, followed by a LINKED COMMAND COMPLETE
message. If the Flag bit was set in the Command Descriptor Block, the drive sends an
INTERMEDIATE status, followed by a LINKED COMMAND COMPLETE
(WITH FLAG) message. The drive then switches the bus to the command phase in
order to receive the next command in the linked chain.
All commands in a linked chain are addressed to the same nexus and are part of a single
task (I/O process). The drive defers any commands that are not part of the linked chain
until the chain is complete. The last command in the chain has the Link bit cleared.
Note: Relative addressing is not supported by the Atlas 10K III disk
drive.