Maxtor ATLAS 10K III - Manual (Page 212)

SCSI Description
5-148 Maxtor Atlas 10K III
0x04
Hdwe
Error
0x40 0x8C DER EC_LBA_ERR LBA mismatch error.
0x40 0x8D HW EC_ETM_FAILURE
ETM test failure, drive failed to
spin.
0x40 0x8E HW
EC_TARGET_RPM_
FAILURE
Could not achieve target RPM.
0x40 0xA0 SVOT EC_SVOT_FAIL_INCMP Test did not complete.
0x40 0xA1 SVOT EC_SVOT_FAIL_CMP
Test completed successfully, but
failed.
0x40 0xA2 SVOT EC_SVOT_INVALID_PARM Invalid parameter was received.
0x40 0xA3 SVOT
EC_SVOT_INVALID_
RECORD_DATA
Invalid data in servo record. Pre-
vented algorithm from complet-
ing.
0x40 0xA4 SVOT
EC_SVOT_RECORD_
TIMEOUT
Servo record did not complete
0x40 0xA5 SVOT
EC_SVOT_READ_SEEK_
FAILED
Read seek failed.
0x40 0xA6 SVOT
EC_SVOT_WRITE_SEEK_
FAILED
Write seek failed.
0x40 0xA7 SVOT
EC_SVOT_RAW_SEEK_
FAILED
Raw seek failed.
0x40 0xA8 SVOT
EC_SVOT_SVO_TEST_
RUNNING
Servo Diagnostic Test running.
0x40 0xA9 SVOT
EC_SVOT_INVALID_97_
98_SEQ Invalid 97/98 super cmd seq.
Must send 97 before 98
0x40 0xAA SVOT
EC_SVOT_CMD_97_
RUNNING Super Command 97 already run-
ning.
0x40 0xAB SVOT
EC_SVOT_CMPLX_MAG_
IS_0
Complex magnitude is zero.
0x40 0xAC AVAIL
EC_SVOT_BCV_WRITE_
FAILURE Could not complete the
low-level bcv write function
0x40 0xAD AVAIL
EC_SVOT_CMPLX_DIV_
BY_0 Got a divide by zero error in com-
plex divide.
0x44 0x00 SYS EC_ASSERT_ERROR
Logical assertion (firmware con-
sistency check)
0x44 0x84 SYS EC_INSUF_BUF
Insufficient buffer memory for
operation
0x90 0x01 SER
EC_SERIAL_RECEIVE_
ERROR
Serial Port Packet Receive Error.
5GPUG
-G[
5GPUG
%QFG
5GPUG
3WCNKHKGT %CVGIQT[
/GUUCIG /GCPKPI