Maxtor ATLAS 10K III - Manual (Page 107)

SCSI Description
Maxtor Atlas 10K III 5-43
 /QFG 2CIG 6[RGU
The drive maintains three distinct sets of mode pages. They are the current page, the
default page, and the saved page. The drive also reports a fourth set of changeable pages.
The page types are defined in Table 5-54.
Table 5-54 Mode Page Types
2CIG 6[RG &GHKPKVKQP
Current
The EWTTGPV mode page set applies to all KPKVKCVQTU and defines the drive’s mode. The
SCSI-2 specification states that a drive can maintain Mode parameters on a per-ini-
tiator basis if it so chooses. The Drives do not support this option.
The EWTTGPV mode page set contains the values supplied in the last MODE SELECT
command received from an initiator. If no initiator has sent a MODE SELECT com-
mand since the drive was last reset or powered up, the current pages contain
• 5CXGF values if saved pages exist (from a previous MODE SELECT command SP
parameter).
•
&GHCWNV values if pages have never been saved.
The drives generate a Unit Attention condition for all initiators (except for the one
that was the source of the MODE SELECT command) whenever one initiator modi-
fies the Mode parameters.
Default
The FGHCWNV mode page set contains the factory default values that are listed in each
page’s description.
Saved
The UCXGF mode page set contains values preserved in the drive’s non-volatile mem-
ory by a previous SP-modified MODE SELECT command.
Changeable
The EJCPIGCDNG mode page set provides a means for an initiator to determine which
pages it is allowed to change and the specific bits within those pages that it is al-
lowed to change. This page set is read-only and is fetched with a MODE SENSE com-
mand.