Table 3-2, Table 3-2 fo – Maxtor ATLAS 10K III User Manual
Page 38
Installation
3-12 Maxtor Atlas 10K III
6CDNG
SCSI ID Pin Assignments (SCA-2 Connector Versions of the Disk Drive)
Note:
0 indicates an open circuit from +2.4 V to Vcc +0.5 V, and 1
indicates ground from 0.5 V to +0.4 V.
5RKP 7R HQT VJG 2KP 5%# %QPPGEVQT 8GTUKQPU
Maxtor Atlas 10K III drives have three Spin Up modes:
Option 1
Spin up occurs immediately when power is applied.
Option 2
Drive spin up occurs after a predetermined delay following power on.
Set the delay parameters with the MODE SELECT Command,
Maxtor (Vendor) Special Function Control Page (39h).The delay is
equal to a user-specified multiplier multiplied by the numerical SCSI
ID of the drive. This will give a staggered spin-up in multiple-drive
installations.
Option 3
Drive spin up is controlled by the START STOP UNIT command.
SCSI ID
Location on SCA Connector
ID3 - Pin 80
ID2 - Pin 40
ID1 - Pin 79
ID0 - Pin 39
0
0
0
0
0
1
0
0
0
1
2
0
0
1
0
3
0
0
1
1
4
0
1
0
0
5
0
1
0
1
6
0
1
1
0
7
0
1
1
1
8
1
0
0
0
9
1
0
0
1
10
1
0
1
0
11
1
0
1
1
12
1
1
0
0
13
1
1
0
1
14
1
1
1
0
15
1
1
1
1