Maxtor ATLAS 10K III - Manual (Page 224)

SCSI Description
5-160 Maxtor Atlas 10K III
 5''-  %QOOCPF $J
The SEEK (10) command uses a 10-byte Command Descriptor Block to request the
drive to send the drive heads to the requested Logical Block Address. The drive
responds by placing the heads at the correct Logical Block Address. When the heads
are at the specified Logical Block Address, they are not guaranteed to stay in that
position since periodic calibrations may send them to a different cylinder. The data
format is shown in Table 5-196.
Table 5-196 SEEK (10) Command Descriptor Block-Data Format
$KV
$[VG
       
0 Operation Code (2Bh)
1 Reserved
2 - 5 Logical Block Address
6 - 8 Reserved
9 Control