4 hardware requirements, 4 hardware requirements -4 – Maxtor ATLAS 10K III User Manual
Page 26
General Description
2-4
Maxtor Atlas 10K III
2TQFWEV '/+'/5 3WCNKHKECVKQPU
• CE Mark authorization is granted by TUV Rheinland in compliance with
our qualifying under EN 55022:1994 and EN 50082-1:1997.
• C-Tick Mark is an Australian authorization marked noted on Maxtor’s
disk drive products. The mark proves conformity to the regulatory
compliance document AS/NZS 3548: 1995 and BS EN 55022: 1995.
• Maxtor’s disk drives are designed as a separate subassembly that conforms
to the FCC Rules for Radiated and Conducted emissions, Part 15 Subpart
J; Class B when installed in a given computer system.
*#4&9#4' 4'37+4'/'065
The Maxtor Atlas 10K III hard disk drive is compatible with host computers and
controllers that provide a 68-pin Wide, or 80-pin SCA-2 interface. A 50-pin to 68-
pin adapter is required to use the 68-pin Wide drive in a 50-pin cabling configuration.
Termination is required on the Maxtor Atlas 10K III Hard disk drives as they do not
support on-board SCSI termination.