Muratec MFX-1500 - Manual (Page 110)

Beyond the basics
2.62
Note: If you make a mistake or want to erase characters entered in a previous setting,
press
CANCEL to erase leftward. Or, if you want to change just one character in
the number, press to move the cursor leftward, or to move it rightward,
to that character and press CANCEL to erase it. Then re-enter until the number
is just as you want it.
6. Now, while you still can see the fax number on the display, press
COMMUNICATION OPTIONS , ENTER . The display shows:
Delayed
Enter Time: 11/20:30
7. There’s a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of the
month (For example, “Do this at 5:05
PM on the 30th.”)
To select this option, use the numeric keypad to enter the date and
time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2: Perform the command at a certain time each day you press the key.
(For example, “Do this at 5:05
PM today.”)
To select this option, use the numeric keypad to enter 0, 0
(i.e., 00), and then the time when the fax could perform
the command:
Delayed
Enter Time: 00/17:05
8. Press ENTER , ENTER .
9. The display now shows the next programmable one-touch key.
If you do not wish to enter or change any other key’s programming, press
STOP to return your machine to its usual standby mode.
If you do wish to enter or change this key’s programming, go back to step 3.
If you wish to enter or change another key’s programming, go back to step 2.
Programming a broadcast
Note: To erase a programmable one-touch key, refer to page 2.71.
Programming a broadcast is very similar to programming a delayed transmission
except that, rather than specifying just one phone number, you set up multiple
numbers to which the transmission should go.
To program a broadcast into a programmable one-touch key:
1. Change to the Fax mode then press PROGRAM , C , 1, ENTER . The display either
shows:
Select Program No.
73:No Number Stored
. . . or indicates a command already is programmed into this key.
If 73 is the key you want to program, skip to step 4. (However, our examples
from here will say “79” rather than “73.”
2. Select the key in which you want to program a command or change a
previously stored command — if necessary, turn the fliptab to see it, as
described earlier — and then press it. Here, we’ve selected 79.
Select Program No.
79:No Number Stored
3. If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4. Press ENTER . The display now shows either:
79:Fax Number
_ or 79:Fax Number
9-5558743
5. Use the numeric keypad to enter up to 220 fax numbers — any combination of
call groups, other one-touch keys, speed-dial numbers and numbers you enter
with only the numeric keypad.
Important: Do not press ENTER .
Between each number or call groups, press BROADCAST to enter a comma.
Important: Do not insert a comma after the last number.
To enter a speed-dial number, press SPEED DIAL / TEL INDEX and the number’s
three-digit identifier.
To enter a call group, press GROUP DIAL and the group’s identifier number.
79:Fax Number
G5,01,S006,9-5552_