Muratec MFX-1500 - Manual (Page 54)

Beyond the basics
2.6
Setting the transmission confirmation stamp
You can set your fax machine so that it will automatically place a small stamp mark
on the front of each original document that it successfully scans.
Note: This feature is available only for documents through the document feeder.
Important: Be sure that this feature is turned off if you are sending original
documents you don’t want the fax to stamp.
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY / FAX to change to Fax mode.
2. Press PROGRAM , J , 1, 5, ENTER . The display shows your fax’s current stamp
setting:
Stamp: Off
Program/Enter
If the setting you see is acceptable, skip to step 4.
Otherwise, proceed to step 3.
3. To change the setting, press PROGRAM once or twice until your chosen setting
appears. In this example, we’ve chosen On.
Stamp: On
Program/Enter
4. Press ENTER to save the setting.
Setting the language
While English is the language in which your machine initially is set to display
messages and print reports, you can set it to “speak” French or Spanish, too! As you
give the order for the machine to change languages, it “rolls” from English to French
to Spanish and then back to English.
To make the change from one language to the next, change to the Fax mode then
press
PROGRAM , #.
What is it?
If, after making a language change, you’re not sure which language is showing, press
PROGRAM (do not press ENTER ), and decide based on what results on the display:
is French
is Germany.
If the language you see is the one you want, press STOP to return to standby mode.
If you want to change the language, press STOP to return to standby mode and then
press PROGRAM , # again to go to the next language in the cycle.
Printing your settings
After you have your machine set as you want, have it print a settings list. We
recommend this particularly if you’ll be sharing the machine with other users, who
might change the settings for one reason or another.
With this list, you can quickly confirm that all settings are as you want, without
having to go back and check them on the machine. Or, if you do need to undo
someone else’s unauthorised (or even authorised) changes, this list guides you in
returning the machine to your preferred settings.
Note: Some settings on the list effect only certain operations we’ll explain later.
Please refer to the index at the end of these instructions to locate any setting you don’t
recognise or understand.
To print the settings list:
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY / FAX to change to Fax mode.
2. Press PROGRAM , J , 2, 1, ENTER . The display will show the following as the list
prints:
Print Settings
** Printing **
Printing a program list
You also can program your machine to print a program list. This list gives a brief
summary of the various instructions available on your fax machine, organised in a
“program tree” so you can see the key combinations related to each instruction.
Note: Some settings on the list effect only certain operations we’ll explain later.
Please refer to the index at the end of these instructions to locate any setting
you don’t recognise or understand.
To print a program list, press PROGRAM , *, 8. Your machine will print the list.
Note: If you have certain options installed on your machine, the list will be two
pages in length, due to the greater number of capabilities your machine
therefore will have.
A Num. Une-Touche
Program./Val.
A Zielwahl
Programm/Eing.