Muratec MFX-1500 - Manual (Page 130)

Just in case …
3.10
What you see on the display What it means/What to do
Please Replace Toner Your toner cartridge is empty.
Replace the toner cartridge.
Please Supply Paper The paper cassette or multiple paper feeder tray is out
of paper.
Add paper to the cassette and/or the tray.
Please Wait Your fax machine’s printer is either warming up or
busy.
Please wait until the fax is finished printing and then
re-try your command or operation.
Polling In Use You tried to store the polling document in your fax
machine, where one already had been stored.
Wait for the fax to complete the regular polling
operation, then try again.
Printer In Use The command you’re trying to enter requires the use
of the printer, which is already in use.
Wait for the fax to finish printing, then try again.
Protect Doc. Stored A received document was in your fax’s memory when
you tried to turn off the security reception passcode.
Print the received document from your fax’s memory,
then retry the desired operation.
Remove Tray Paper Your fax machine has detected a paper jam in the
Open & Close Top Cover multiple paper feeder tray.
See page 3.4 for instructions on clearing the jam.
Scanner In Use The command you’re trying to enter requires the use
of the scanner, which is already in use.
Wait for the fax to complete the scan, then re-try the
desired command.
Stop Scanning You opened the top cover while the machine
ContStor Enter/Cancl was scanning the document (for either faxing or
copying) using the
FBS .
To continue the scan, press ENTER .
To abort the scan, press CANCEL .
Sub-address In Use You tried to enter a sub-address identical to one
already being used in another F-Code box.
Enter a different sub-address.
What you see on the display What it means/What to do
Toner Low Your fax machine is almost out of toner.
Contact your authorised Muratec dealer to purchase
a new toner cartridge if you don’t already have one.
Too Many Characters You attempted to enter too many numbers or other
characters in the current operation.
Press
CANCEL to delete the extra characters, then try
again. You may wish to review the operation’s
appropriate instructions.
Too Many Locations You tried to enter too many numbers for a broadcast.
You can enter up to 10 one-touch or speed-dial
numbers and numbers entered through the numeric
keypad.
Press
CANCEL to delete the extra numbers and then
try again.
Errors
When sending faxes, your machine occasionally will run into communication errors.
These can be caused by anything from lightning to telephone line interference. (These
same factors causes the static, or line noise, you sometimes hear on phone calls.)
They also can be caused by problems with the fax machine at the other end of the
line.
Often, simply trying your call again is all that’s necessary. However, if the problem
persists regularly, call your local telephone company for help. If that call doesn’t help
and the problem persists regularly, call your authorised Muratec dealer.
Error reports
When an error occurs, your fax machine prints an error report. Each fax error report
lists an error message which includes:
• A possible solution to the problem
•
The sending location (if the remote fax stores a Location ID of its own)
•
The result --- which is a special error code
•
A sample of the document’s first page.
Kinds of error codes
The error code listed in the “Result” column of the error report indicates the specific
problem encountered:
• “D” codes --- Occur while dialling
•
“R” codes --- Occur during reception
•
“T” codes --- Occur during transmission