Muratec MFX-1500 - Manual (Page 36)

Getting started
1.27
8. At the end of the transmission, your fax machine beeps and displays:
972-555-2009
** Completed **
Cancelling sending a document
To cancel a non-memory transmission, press STOP two or three times (if you’re using
the ADF , the document will finish feeding through the machine) until the machine
returns to standby mode.
To cancel a memory transmission, you’ll need to use the Review function (see page
1.28 for an introduction).
If the call doesn’t go through: redialling
If the call fails (and you were not using either the monitor speaker or a handset), your
machine’s display will show something similar to:
** Auto Redial **
This means your fax machine is set to redial, automatically, the fax call you just tried.
While in this Auto Redial mode, the machine can receive faxes and makes as many as
99 fax transmissions.
If you dialled without using either the monitor speaker or an optional handset, your
fax automatically redials the number every few minutes (you set the interval; see
“Making redial settings,” right column) until one of these happens first:
It reaches the remote fax machine.
It has automatically redialled the number for the last try (again, see “Making redial
settings,” right column).
Note: If you used either the speaker or a handset, you must redial manually
(right column).
If the last try fails, your machine may print (and/or display) error messages. For more
information, see pages 3.7–3.12.
Redialling manually
You always can redial fax or voice calls manually; and, again, you must redial
manually if you dialled by using either the monitor speaker or a handset.
To redial a fax call manually without using either the monitor speaker or an optional
handset:
1. Confirm that the document is still in the feeder and that your desired resolution
and contrast settings are still correct.
2. Press REDIAL / PAUSE .
To redial a fax call manually by using either the monitor speaker or an optional
handset:
1. Confirm that the document is still in the feeder and that your desired resolution
and contrast settings are still correct.
2. Obtain a dial tone: either press MONITOR / CALL or lift the handset.
3. Press REDIAL / PAUSE .
4. When you hear fax tones from the remote unit, press START .
Note: If a person answers the phone, tell him or her you’re trying to send a fax.
When his/her machine sends you fax tones, then press
START .
To redial a voice call manually using an optional handset:
1. Obtain a dial tone: either pressing MONITOR / CALL or lift the handset.
2. Press REDIAL / PAUSE . When the other person answers, speak to him/her on the
handset.
Making redial settings
It’s up to you how many times the fax redials a number and how long it waits during
redials (that’s called the redial interval). Here’s how to make those settings:
1. Change to the Fax mode, then press PROGRAM , J , 0, 6, ENTER .
Set # Of Redials
# (2-5): 2
If the number of rediallings you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.