Muratec MFX-1500 - Manual (Page 116)

Beyond the basics
2.68
8. The display now shows the next programmable one-touch key.
If you do not wish to enter or change any other key’s programming, press
STOP to return your machine to its usual standby mode.
If you do wish to enter or change this key’s programming, go back to step 3.
If you wish to enter or change another key’s programming, go back to step 2.
Programming F - Code transmission
Note: To erase a programmable one-touch key, refer to page 2.71.
Note: For F-Code transmission to work, two things must be true:
•
You must know how the remote fax is using each F-Code ( ITU - T -standard
sub-addressing/password) box to which you’re transmitting — as a bulletin
box or as a security box (obviously, different makers may use slightly
different terms, but the concepts are the same).
•
You must know the remote fax’s ITU - T sub-address and password number
for each box to which you wish to transmit.
To program a F-Code transmission into a programmable one-touch key:
1. Change to the Fax mode then press PROGRAM , C , 1, ENTER . The display either
shows:
Select Program No.
73:No Number Stored
. . . or indicates a command already is programmed into this key.
If 73 is the key you want to program, skip to step 4. (However, our examples
from here will say “74” rather than “73.”
2. Select the key in which you want to program a command or change a
previously stored command — if necessary, turn the fliptab to see it, as
described earlier — and then press it. Here, we’ve selected 74.
Select Program No.
74:No Number Stored
3. If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4. Press ENTER . The display now shows either:
74:Fax Number
_ or 74:Fax Number
9-5557312_
5. Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system may require. The number
can be up to 40 characters in length:
76:Fax Number
9-5550629_
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance numbers), press
to
scroll leftward or to scroll rightward.
Important: Do not press ENTER .
Note: If you make a mistake or want to erase characters entered in a previous
setting, press
CANCEL to erase leftward. Or, if you want to change just
one character in the number, press to move the cursor leftward, or
to move it rightward, to that character and press CANCEL to erase it.
Then re-enter until the number is just as you want it.
6. Now, while you still can see the fax number on the display, press
COMMUNICATION OPTIONS seven times. The following display appears:
7.F-Code Tx
Comm.Option/Enter
7. Press ENTER . The display will show:
Enter Sub-Address
_
8. Use the numeric keypad to enter the ITU - T sub-address for the box to which
you want to send the document. Here, we’ve entered 123456:
Enter Sub-Address
123456_
9. Press ENTER . The display will show:
Enter Password
_
Note: If you know that this sub-address does not have a password, skip to step 11.
10. Use the numeric keypad to enter the appropriate ITU - T password for the box (if
there is one; if there’s not, you may skip to step 11, as explained in the second
Note, below). In this example, we’ve entered 654321.
Enter Password
654321_
Note: If you make a mistake, press CANCEL to back up, then enter the correct
number. When the entry is complete, press ENTER .