Muratec MFX-1500 - Manual (Page 118)

Beyond the basics
2.70
Note: If you make a mistake or want to erase characters entered in a previous
setting, press
CANCEL to erase leftward. Or, if you want to change just
one character in the number, press to move the cursor leftward, or
to move it rightward, to that character and press CANCEL to erase it.
Then re-enter until the number is just as you want it.
6. Now, while you still can see the fax number on the display, press
COMMUNICATION OPTIONS eight times. The following display appears:
8.F-Code Polling
Comm.Option/Enter
7. Press ENTER . The display will show:
Enter Sub-Address
_
8. Use the numeric keypad to enter the ITU - T sub-address for each box
(i. e., ITU - T sub-address number) you want to poll.
For example, here, we’ve entered 123456:
Enter Sub-Address
123456_
9. Press ENTER . The display will show:
Enter Password
_
Note: If you know that this sub-address does not have a password, skip to
step 11.
10. Use the numeric keypad to enter the appropriate ITU - T password for the box (if
there is one; if there’s not, you may skip to step 11, as explained in the first
Note, below). In this example, we’ve entered 654321.
Enter password
654321_
Note: If you make a mistake, press CANCEL to back up, then enter the correct
number.
When the entry is complete, press ENTER .
11. If you want the transmission to begin immediately every time you press the
key, press
ENTER again and skip to step 14.
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
COMMUNICATION OPTIONS , ENTER .
12. There’s a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of the
month (For example, “Do this at 5:05
PM on the 30th.”)
To select this option, use the numeric keypad to enter the date and
time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2: Perform the command at a certain time each day you press the key.
(For example, “Do this at 5:05
PM today.”)
To select this option, use the numeric keypad to enter 0, 0
(i. e., 00), and then the time when the fax could perform
the command:
Delayed
Enter Time: 00/17:05
13. Press ENTER , ENTER .
14. The display now shows the next programmable one-touch key.
If you do not wish to enter or change any other key’s programming, press
STOP to return your machine to its usual standby mode.
If you do wish to enter or change this key’s programming, go back to step 3.
If you wish to enter or change another key’s programming, go back to step 2.