Muratec MFX-1500 - Manual (Page 92)

Beyond the basics
2.44
Dialling from the numeric keypad while using the PIN mask
Note: If the PIN mask feature is off, you dial normally.
If you’ve specified “Mode1” — use “star” power
1. Enter the phone number, then press the * (“star”) key and enter the PIN . The
PIN always goes last. For example, to dial 19725550911 with a PIN of
“123456,” enter 19725550911*123456:
Press Start
19725550911*123456
2. Press START . The PIN disappears from the display, and your machine dials the
desired phone number.
If you’ve specified “Mode2” — the machine guides you
1. Enter the phone number as usual.
Press Start
19725550911_
2. Press START . The display now shows:
Enter PIN Number
_
3. Use the numeric keypad to enter the PIN .
Enter PIN Number
123456_
4. Press START . Your machine will dial the number.
Performing batch transmission while using the PIN mask
Note: The following instructions presume you are familiar with how to set and use
both your machine’s autodialler and its batch transmission feature. If you need
to review, see pages 2.7–2.15 for more on the autodialler and/or pages 2.23–
2.26 for more on batch transmission.
Note: If the PIN mask feature is off, you dial normally.
If you’ve specified “Mode1” or “Mode2”
Important: Any autodialler number you use with batch transmission must include
the
PIN . (To review how to include this information in an autodialler
number, review the Mode 1 instructions under “Autodialling while
using the
PIN mask,” page 2.43.)
Before sending a batch transmission to a desired number the first time, you must store
the
PIN within its batch box. Here’s how:
1. Perform the batch box setting until you’ve entered the batch box number.
The display now asks for the fax number (here, we’ve working with
batch box 1):
1:Fax Number
_
2. Enter an autodialler number, or use the numeric keypad to enter the fax
number, to which the batch transmission should go.
Important: If you’re using an autodialler number, it must contain the PIN , as
mentioned previously.
If you’re entering a number from the numeric keypad, enter the
fax number, followed by the * (“star”) key and then
PIN .
3. Press ENTER to save the setting.
Note: If you press ENTER without entering the PIN , the fax machine beeps,
indicates “No PIN Number” on the display and then returns you to step 2.
Now, you can perform batch transmission to this box while the PIN mask is activated.