Muratec MFX-1500 - Manual (Page 32)

Getting started
1.23
Using memory transmission
Your fax machine has a great memory! and, because it does, it can finish fax jobs
more quickly than otherwise would be possible.
By automatically scanning your fax document into, then transmitting from, its
memory — rather than transmitting each part of the scan only as quickly as the
receiving fax machine can receive it — your fax machine can hand you back your
original document more rapidly.
Here’s a real money saver on long distance fax calls: if you’re transmitting to another
memory-equipped Muratec fax machine, your machine will send the document
directly into the other machine’s memory and hang up! (The receiving machine then
prints out your message from its memory.) This cuts your actual on-line time to a
minimum.
Better still: set up a delayed command (see pages 2.20–2.22) to send your document
to that other Muratec fax machine after hours, and you’ll save two ways on the call:
not only will the call itself be short, but also the line charges will be cheaper!
You can set your fax machine always to transmit from memory as a default.
Note: Whichever choice you make, you can override that choice one transmission at
a time by pressing
MEMORY TRANSMIT . (However, see the “Important” item,
below.) After completing the communication, your fax machine will return to
your desired transmission setting.
Note: Although it’s probably best to decide to transmit from memory, be aware that
certain types of documents can quickly exhaust even your machine’s large
memory supply. Obviously, documents with large numbers of pages qualify;
so do documents with lots of dark areas, since darker pages create more data
for your fax machine to “remember” and send. When the machine’s memory
supply is full, it can transmit only in normal (i. e., non-memory) mode.
Important: When you transmit using the FBS , your machine always transmits from
memory. This choice is available only when you transmit using the ADF .
To make memory transmission the default for transmissions from the ADF :
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY / FAX to change to Fax mode.
2. Press PROGRAM , J , 1, 3, ENTER .
Memory Tx: On
Program/Enter
If the setting you see is acceptable, skip to step 4.
Otherwise, proceed to step 3.
3. To change the setting, press PROGRAM once or twice. In this example, we’ve
chosen Off.
Memory Tx: Off
Program/Enter
4. Press ENTER to save the setting.
Toggling between Fax mode and Copy mode
To toggle (switch between) Fax mode or Copy mode, simply press COPY / FAX .
The glowing LED tells you the current machine mode:
Fax mode Copy mode
COPY FAX COPY FAX