Muratec F-160 - Manual (Page 23)

1.16
Getting started
To redial a fax call manually with the monitor speaker or an optional handset:
1 Make sure the document is in the feeder and that the resolution and
contrast are set.
2 Press MONITOR / CALL or lift the optional handset to get a dial tone.
3 Press REDIAL / PAUSE .
4 When you hear fax tones from the remote unit, press START .
Note: If a person answers the phone, use the optional handset to tell that
person you’re sending a fax. When you hear fax tones, press START .
To redial a voice call manually using the optional handset:
1 Lift the optional handset to get a dial tone.
2 Press REDIAL / PAUSE . When the other person answers, use the optional
handset to speak to that person.
Changing redial settings
It’s up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval). To program
the redial settings:
1 Press / PROGRAM , J , 0, 7, ENTER .
2 Use the numeric keypad to enter the number of redials you want. Choose
from 2 to 5 redials. In this example, we’ve entered 03.
Important: Enter a leading zero when entering a quantity less than 10.
3 Press ENTER to save the setting.
4 The LCD now shows:
5 Use the numeric keypad to enter the length you want between redial
attempts. Choose from 3 to 5 minutes. In this example, we’ve chosen 4.
6 Press ENTER to save the setting.
Review Commands, an introduction
Your fax machine can store many “jobs” in its memory. And it keeps track of each one
by assigning it a command number, like “C01.”
Delayed commands, redial attempts and current fax transmissions are all stored in
your fax machine’s memory and given a command number.
The Review Commands function gives you the power to check on each job (or
command) in your machine’s memory. It also lets you cancel a command if you
decide not to send the document.
To cancel a command:
1 Press REVIEW COMMANDS .
The LCD shows the first command, indicated by its command number and the
phone number it will dial. If a command is in progress, that will be the first
command the
LCD shows:
2 Press or / PROGRAM until the command you want to cancel appears.
3 Press CANCEL . The LCD shows:
4 If you want to cancel this command, press CANCEL again.
5 The LCD now shows the next command.
If you want to cancel it, too, go back to step 4.
If you don’t want to cancel this command but do want to review other
commands, press /
PROGRAM until the command you want appears. Then go
back to step 4.
If you want to stop reviewing the stored commands, press
STOP to return the
machine to standby mode.
For more information on the Review Commands function, see page 2.18.
C01:5552009
Check Program/Cancel
C01:5552009
Program/Cancel
Set Redial Interval
Inter. (3-5): 4
Set Redial Interval
Inter. (3-5): 3
Set # Of Redials
# (02-05): 03
Set # Of Redials
# (02-05): 02