Muratec F-160 - Manual (Page 78)

Beyond the Basics
14 Press / PROGRAM until the mode you want appears.
15 Press ENTER . The LCD asks if you want the confirmation stamp on or off when
using this programmable one-touch number.
16 Press / PROGRAM until the mode you want appears.
17 Press ENTER . The LCD asks if you want the memory transmission on or off
when using this programmable one-touch number.
18 Press / PROGRAM until the mode you want appears.
19 Press ENTER . The LCD asks you for the type of confirmation report you want to
set for this programmable one-touch number.
20 Press / PROGRAM until the mode you want appears.
21 Press ENTER . The LCD asks if you want to send a cover page for this program-
mable one-touch number.
22 Press / PROGRAM until the mode you want appears.
23 Press ENTER . The LCD asks if you want to turn the Copy & Fax feature on or
off for this programmable one-touch number.
24 Press / PROGRAM until the mode you want appears.
25 Press ENTER .
26 The LCD now displays the next programmable one-touch key.
If you do not want to enter or change any other key’s programming, press STOP .
Your machine returns to standby mode.
If you do want to enter or change this key’s programming, go back to step 4.
If you want to enter or change another key’s programming, go back to step 2.
Programming a broadcast / group
Programming a broadcast is very similar to programming a delayed transmission.
But instead of sending to just one phone number, you set up multiple numbers for
the transmission.
To program a broadcast / group into a programmable one-touch key:
1 Press / PROGRAM , C , 1, ENTER . The LCD shows the first empty programmable
one-touch number available:
Note: If a programmable one-touch number other than 65 appears on the
LCD , it means that you have already entered a number for 65.
Note: To erase a programmable one-touch key, see page 2.58.
2 Press the key you want to program or change. Here, we’ve selected 66.
Note: If your previous command for this key was for a broadcast / group
transmission and you want to keep this key programmed for a broad-
cast / group transmission, use these instructions to make changes. But
if you want to assign this key to a completely different operation (for a
delayed transmission, for example), then you first must erase the
stored command before programming the new one.
3 If you want to select a different programmable one-touch key than the one
that appears on the
LCD , press that key now.
4 Press ENTER . The LCD asks for the type of operation you want to program into
the one-touch:
Note: If changing a previously stored command, skip to step 7.
5 Press / PROGRAM until “Comm.” appears.
6 Press ENTER . The LCD now shows either
or
66:Fax#/Com-Options
9-5558743_ 66:Fax#/Com-Options
_
66: Type: Comm.
Program/Enter
66: Type: Comm.
Program/Enter
Select Program No.
66:No Number Stored
Select Program No.
65:No Number Stored
68: Copy&Fax: ---
Program/Enter
68: Cover Page: ---
Program/Enter
68: Conf.Report: ---
Program/Enter
68: Memory Tx: ---
Program/Enter
68: Stamp: ---
Program/Enter
2.47