Muratec F-160 - Manual (Page 38)

Beyond the Basics
Your fax machine’s autodialler stores your most frequently called phone and fax
numbers for instant recall so you don’t have to remember them. It’s something like
an electronic phone book.
Autodialler basics
How do you autodial?
There are two kinds of autodialler numbers. The difference between the two is how
you dial them:
Type How to dial Amount stored
One-touch Press one of the keys, marked 01–64 64
on the right side of the control panel
Speed-dial Press SPEED DIAL / TEL INDEX followed by a 136
three-digit identifier, from 001 to 136
Total amount of numbers stored 200
Autodialling fax and phone numbers
Your fax machine’s autodialler will hold more than just fax numbers. You can store
phone numbers, too.
This is because when you use the autodialler to dial a number, the fax checks to see
if there’s a document in its feeder. If there is, the machine dials as a fax machine. If
there isn’t, it dials as a phone.
Location ID s and the EasyDial directory
When you store numbers in your autodialler, you can give these numbers descriptive
names, such as “Chicago office” or “Billing department”. Your machine calls this
name a Location
ID .
Your machine’s autodialler sorts these location ID s alphabetically. Using your
EasyDial directory, you can look up these numbers by their descriptive names, just
as if you were using a phone book.
We’ll explain how to store the numbers and location
ID s in the next few pages. The
EasyDial directory is discussed in detail on page 2.15.
Special Dialling Characters
Your fax machine allows you to enter special dialling characters when programming
the autodialler. These characters include hyphens and dashes, which make phone
numbers easier to read, and special characters needed for international calls.
The chart below briefly describes each of these characters. It also tells you what
keys to press on your fax machine to store those characters in your autodialler:
Char. What it does Keystroke(s)
– Makes long numbers easier to read.
DIALING OPTIONS (once)
Doesn’t change fax machine operation.
/ (Has no effect in the Europe.) DIALING OPTIONS (twice)
! (Has no effect in the Europe.) DIALING OPTIONS (3 times)
Enters a pause, during the dialling of
long-distance numbers or when you’re
REDIAL / PAUSE [after entry of at
–/
dialling through PABX . Each pause uses least one other character]
two of the characters you can store in
one phone number.
If your fax machine is on a pulse (not
tone-dialling) line, switches from pulse-
dialling to tone (“
DTMF ”)-dialling. DIALING OPTIONS (once),
–! Use after the actual phone number but then PROGRAM (once), then
before any characters (such as a long- DIALING OPTIONS (3 times),
distance carrier’s access code) which then PROGRAM (once)
must be in DTMF tone. Do not use on a
tone line.
Enter “flash” signal to exchange PABX
/ to PSTN before actual phone number. Soft key which registered the
However, “/” must be entered to the flash signal. (See page 2.24.)
first of number
2.7
Autodialler