Muratec F-160 - Manual (Page 85)

Beyond the Basics
31 The LCD now displays the next programmable one-touch key.
If you do not want to enter or change any other key’s programming, press STOP
to return your machine to standby mode.
If you do want to enter or change this key’s programming, go back to step 4.
If you want to enter or change another key’s programming, go back to step 2.
Programming F-Code polling
For this operation to work, three things must be true:
• The document which you’re polling must exist in the remote fax’s F-Code box (
ITU - T
standard sub-addressing/password box).
• You must know the remote fax’s ITU - T sub-address and password (if any) for each
box you want to poll.
To program an F-Code polling operating into a programmable one-touch key:
1 Press / PROGRAM , C , 1, ENTER . The LCD shows the first empty programmable
one-touch number available:
Note: If a programmable one-touch number other than 65 appears on the
LCD , it means that you have already entered a number for 65.
Note: To erase a programmable one-touch key, refer to page 2.58.
2 Press the key you want to program or change. Here, we’ve selected 71.
Note: If your previous command for this key was for an F-Code polling oper-
ation and you want to keep this key programmed for an F-Code
polling operation, use these instructions to make changes. But if you
want to assign this key to a completely different operation (for a
delayed transmission, for example), then you first must erase the
stored command before programming the new one.
3 To select a different programmable one-touch key than the one that appears
on the
LCD , press that key now.
4 Press ENTER . The LCD asks for the type of operation you want to program into
the programmable one-touch:
Note: If changing a previously stored command, skip to step 7.
5 Press / PROGRAM until “Comm.” appears.
6 Press ENTER . The LCD now shows either:
or
7 Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length:
Your display shows only 20 characters at a time. To view characters beyond
those 20, press
to scroll to the left or / PROGRAM to scroll to the right.
Important: Do not press ENTER .
Note: To erase characters, press CANCEL to erase to the left.
To change just one character in the number, press to move the cur-
sor left, or / PROGRAM to move it right. Press CANCEL to erase it.
Then re-enter the number correctly.
8 Now, while you can still see the fax number on the LCD , press COM - OPTIONS
four times and then press ENTER . The LCD shows:
9 Use the numeric keypad to enter the ITU - T sub-address for the box you want
to poll. Here, we’ve entered 123456:
Enter Sub-Address
123456_
Enter Sub-Address
_
71:Fax#/Com-Options
9-5558422_
71:Fax#/Com-Options
9-5558743_ 71:Fax#/Com-Options
_
71: Type: Comm.
Program/Enter
71: Type: Comm.
Program/Enter
Select Program No.
71:No Number Stored
Select Program No.
65:No Number Stored
2.54