Muratec F-160 - Manual (Page 74)

Beyond the Basics
6 Press ENTER .
If you’ve entered an incorrect I . D . code, your fax machine rejects the attempt
and returns to standby mode.
If you’ve entered the correct
I . D . code, the display shows:
Note: If you want to quit without erasing the F-Code box you’ve selected,
press / PROGRAM . The fax will return to step 2.
Note: If you want to quit without erasing any F-Code box, press STOP .
The machine returns to standby mode.
7 Press ENTER to erase the F-Code box.
To erase another F-Code box, repeat steps 2-7.
To finish, press
STOP .
F-Code transmission and polling
With F-Code, your machine can send secure transmissions, perform relay broadcast
initiations and even poll from other
ITU - T -equipped machines, regardless of manu-
facturer.
You can do this two ways:
• Using the programmable one-touch key (see pages 2.52-2.55)
• Entering the
ITU - T sub-address and password directly, which is what we’ll
describe here.
Note: For F-Code communication to work, three things must be true:
• The remote fax machine must support ITU - T sub-addressing
• The remote fax must have a mailbox with an ITU - T sub-address created
on it
• You must know the ITU - T sub-address and password (if any) for the
remote machine’s mailbox
F-Code transmission
1 Insert the document.
2 Adjust the resolution and contrast if necessary.
3 If you want to toggle between manual transmission and memory transmis-
sion, press
MEMORY TRANSMIT .
4 Press COM - OPTIONS five times and then press ENTER .
5 Use the numeric keypad to enter the appropriate sub-address in the remote
machine. In this example, we’ve entered 123456.
Note: If you make a mistake, press CANCEL to erase the character, then
enter the correct number.
6 Press ENTER . The LCD shows:
Note: If this sub-address does not have a password, skip to step 8.
7 Use the numeric keypad to enter the password. In this example, we’ve
entered 654321.
8 Press ENTER . The LCD shows:
9 Enter the fax number either by pressing a one-touch key, entering a speed-
dial number or dialling from the numeric keypad. Do not press
START .
10 What you do now depends on when you want the transmission to begin.
• To have it begin now, skip to step 13.
• To delay it, go on to step 11.
11 Press COM - OPTIONS , ENTER . The LCD shows:
12 Use the numeric keypad to enter the day and time when the transmission
should begin, then press
ENTER .
Delayed
Enter Time: 15/17:05
Enter Fax Number
_
Enter Password
654321_
Enter Password
_
Enter Sub-Address
123456_
Enter Sub-Address
_
03:Erase F-Code Box
** Complete **
03:Erase F-Code Box
Check Program/Enter
2.43