Sanyo CHX06052 - Manual (Page 188)

6-10
Service Checker
1. Outdoor Unit Maintenance Remote Controller
Setting mode 2
Press the (CHECK) button, (SET)
button and the (CANCEL) button simultaneously for
4 seconds or longer.
Press the temperature setting and
buttons to change the item code. The item codes
and setting data are shown in the table below.
Press the timer time and buttons to
change the setting data.
To confirm the changed setting data, press the
(SET) button.
(At this time, the “ ” display stops blinking
and remains lit.)
“ ” blinks when this mode is engaged, and
when this mode is engaged, “Now Setting” is dis-
played blinking, and the address of the outdoor
unit that is being set “System XX-YY” (System XX
= System address, YY = Outdoor unit address),
the item code No. (values from the table below),
and the corresponding settings data (6 digits) are
displayed. The item code number (values shown
in the table below) and the corresponding setting
data (6 digits) are also displayed. (The 6 digits of
the setting data are displayed by changing
between the first 3 digits (Fig. (C)) and the last
three digits (Fig. (D)). When the first 3 digits are
displayed, the top dot of the colon is illuminated.)
To exit setting mode, press the (CHECK)
button. Returns to normal display mode.
Refrigerant type: (C) and (D) are displayed alternately.
The example here (000, 410) indicates R410A.
(C) Display of first 3 digits
(D) Display of last 3 digits
Outdoor unit capacity
0 = Disabled 80 (25 Type) 112 (36 Type) 140 (48 Type) 160 (60 Type)
224 (70 Type) 280 (90 Type) 355 (115 Type) 400 (130 Type) 450 (140 Type)
Parameter
CODE
NO.
Description (SET DATA)
2
4
3 1 5