Sanyo CHX06052 - Manual (Page 58)

2-40
Remote Control Functions
3. Timer Remote Controller (RCS-TM80BG)
Fire prevention input terminal (Setting data = 0002)
The pulse/static setting is not necessary (disabled).
Description of operation: When the HA signal turns ON, operation changes to stop and central 1 (start/stop by
remote controller prohibited). When this signal is OFF, use of the remote controller is permitted.
This function is used with Type A only.
Type U is not compatible with the fire prevention function. Therefore this function
cannot be used in a system where both A and U units are present.
CAUTION
ON
OFF
HA operation signal
(T10 1-2 input)
Stop and remote controller prohibited
(central 1)
Remote controller permitted
Test run
Operation with
forced thermostat
ON
Press and hold the button
for 4 seconds or longer.
Sensor
temperature
display Temperature
display from each
sensor
Press and hold th and e
buttons for 4 seconds or longer.
buttons for 4 seconds or longer.
Servicing check
display Alarm history
display Press and hold the
Current operation is
maintained.
Simple settings
Filter lifetime,
operating mode
priority, central
control address,
and other settings
Detailed settings
System address,
indoor unit address,
central control
address, and other
settings
Press and hold the ,
and buttons for 4 seconds
or longer.
Press the
button.
When settings are made
from a remote controller,
the indoor unit where that
remote controller is
connected stops.
Automatic
address
Automatic address
setting based on
command from the
wired remote
controller
Press and hold th and the e
timer operation buttons
for 4 seconds or longer.
Automatic reset
Address change
Change of indoor
unit address
Entire system stops.
and
buttons for 4 seconds
or longer.
Press and hold the and
Press the
button.
Press and hold th and the e
timer operation buttons
for 4 seconds or longer.
MiniECO-i.indb 40 2007/06/20 16:28:54