Sanyo CHX06052 - Manual (Page 25)

2-7
Remote Control Functions
2
2. Wireless Remote Controller
The wireless remote control unit sends the temperature signal to the air
conditioner regularly at five-minute intervals. If the signal from the wireless
remote control unit stops for more than ten minutes due to the loss of the
wireless remote control unit or other trouble, the air conditioner will switch to
the temperature sensor which is built into the indoor unit and control the room
temperature. In these cases, the temperature around the wireless remote
control unit may differ from the temperature detected at the air conditioner's
position.
When low fan speed is selected and the air conditioner is in cooling opera-
tion at a low outdoor temperature of less than 50°F (10°C), the air conditioner
may automatically switch to medium fan speed to prevent freezing.
Indicator when swing operation is stopped
Fan and heating Cooling and drying
During cooling and drying, the flap does not stop at the downward position.
Even if the flap is stopped at the downward position during the swing operation, it does not
stop until it moves to the third position from the top.
NOTE This function is available only for models X, A, T and K.
J: TIMER SET button Use this button while the unit is operating to switch between timer settings.
(OFF Timer)
(OFF Cycle Timer)
(ON Timer)
: The air conditioner stops after a preset time elapses.
: The air conditioner always stops after a preset time elapses.
: The air conditioner starts after a preset time elapses.
K: Time setting buttons : Press this button to increase the time.
: Press this button to decrease the time.
L: SET button Use this button to set the timer.
M: CL button Use this button to clear the timer setting.
N: VENTILATION button This is used when a ventilation fan (available commercially) is connected. Pressing the
VENTILATION button turns the fan on and off. The ventilation fan also turns on and off when
the air conditioner unit is turned on and off. (The display of the remote control unit shows
"
" while the ventilation fan is running.)
* If the VENTILATION button is held down for 4 or more seconds when the batteries have
been replaced, "
" appears on the display, and the ventilation fan can be used.
O: Remote control sensor This detects the temperature around the remote control unit when the remote control unit
position has been selected using the sensor button.
p: ACL button (ALL CLEAR) Puts the wireless remote control unit into pre-operation status. This is used after the batter-
ies have been replaced or when the slide switch setting has been changed.
Q: Slide switch This switch is for setting the operation mode of the indoor unit and setting the flaps.
NOTE
MiniECO-i.indb 7 2007/06/20 16:28:09